Every component of crawl space mold addressed — not just the visible surface growth.
🔍
Crawl Space Mold Assessment & Moisture Mapping
Our Fulton, MD crawl space inspectors enter the space with calibrated moisture meters and assess joist moisture content readings at regular intervals, map the extent of visible fungal growth, evaluate vapor barrier condition, and measure ventilation cross-flow. Findings documented with photos and written scope before any work begins.
🔨
Joist & Subfloor Sheathing Mold Removal
HEPA vacuum and wire-brush removal of fungal growth from accessible joist and sheathing surfaces. Where structural integrity is compromised by fungal digestion, affected sections are removed and sistered with treated lumber.
💧
Vapor Barrier Repair & Replacement
Ground cover vapor barrier is the first line of defense against crawl space moisture. Torn, absent, or undersized vapor barriers allow ground evaporation to raise relative humidity in the space to mold-favorable levels. We repair or replace with 6-mil minimum reinforced poly — properly overlapped and secured to footings and piers.
🏔
Encapsulation for Severe Moisture Environments
Full crawl space encapsulation — sealed ground cover, insulated perimeter walls, and conditioned air — is warranted in high-moisture-load situations where passive ventilation is insufficient. We assess your specific Fulton, MD conditions before recommending encapsulation vs. enhanced ventilation.
⚡
Ventilation Correction & Dehumidifier Installation
Where crawl space cross-ventilation is inadequate, our Fulton, MD team identifies additional vent locations, sizes existing vents against square footage, and where appropriate, installs a dedicated crawl space dehumidifier with external drain or condensate pump. Mechanical dehumidification is sometimes the most practical solution for chronically humid Fulton crawl spaces.
📄
Post-Remediation Clearance & Moisture Verification
Post-remediation moisture re-check plus independent post-removal air sampling. Joist moisture content below threshold, post-clearance air sample confirming reduced spore counts — both documented in your written clearance report.
